TES MicroFlip N20 Motor Reverser PCB for Goose Belt Purger

Details

A thumb-sized board that goes between your controller and the N20 motor on a Goose Belt Purger. The protection parts the GBP docs ask for are already on the board, so you don't have to solder a diode, resistor and capacitor onto the motor leads. Belt running the wrong way? Flip the slide switch instead of re-crimping the wires.

Specs

• For N20-size brushed DC gear motors, 3–12 V, up to 1 A
• DPDT slide switch that swaps both motor leads
• RC snubber on board against brush noise and voltage spikes
• 2-pin JST-PH connector
  

In the bag

• MicroFlip PCB
• 1× 2-pin JST-PH housing with 4 crimp pins (you need 2, the other 2 are spares)

Good to know

The board is rated for 12 V. If your fan outputs run at 24 V, take the motor power from a 12 V or 5 V output instead.

In stock in the Netherlands. It ships from my workshop within 2–4 working days, no import fees or customs on top.

Designed by Tröndle Embedded Systems (TES) in Switzerland, open source under GPL-3.0.